Steering Bearing; Removing The Rear Wheel - PIAGGIO Vespa LX 150 4T Euro 3 Service Station Manual

Vespa LX 125 - 150 4T Euro 3
AGIP GREASE PV2 Grease for control levers
on the engine
White anhydrous-calcium based grease to protect
roller bearings; temperature range between -20 °
C and +120 °C; NLGI 2; ISO-L-XBCIB2

Steering bearing

Removal
- Use the specific tool both to remove the lower seat of the upper bearing and to remove the upper seat
of the lower bearing fitted on the chassis.
N.B.
TO REMOVE THE LOWER SEAT OF THE LOWER STEERING BEARING JUST USE A SCREW-
DRIVER AS A LEVER BETWEEN THE SEATING AND THE SLEEVE.
Specific tooling
020004Y Punch for removing fifth wheels from headstock
- Remove the fifth wheel fitting and the dust guard
on the steering tube as shown in figure, using the
specific tool. Proceed giving a few taps with the
mallet.
Specific tooling
020004Y Punch for removing fifth wheels from
headstock
- Refit the fifth wheel fitting and the dust guard on
the steering tube until they stop, using the specific
tool.
Specific tooling
006029Y Punch for fitting fifth wheel seat on
steering tube
Rear

Removing the rear wheel

-Straighten the split pin and remove the cap.
Suspensions
SUSP - 13