Fujitsu PRIMERGY LTO3 User Manual page 87

Classificat
No Check
ion
❑
8
Installation
environment
❑
9
Others
❑
10
Check item
Is the environment This product is susceptible to its installation
of this product (the environment (especially dust) because the data-
server if it is built in recording surface is exposed inside the device. The
the server) dust- closer to the floor, the higher the dust level is in general,
free? so it is recommended to install this product away from
the floor, such as on a desk.
* Install this product in less dusty environments,
referring to the [Examples of installation
environments to avoid].
[Examples of installation environments to avoid]
• On the floor.
• High-traffic areas
• Areas close to open doors/windows, Especially,
where affected by the external environment, such as
sandy dust, car exhaust emissions, etc.
• Areas close to air ventilating ducts. (be careful of air
conditioners, exhaust fans, etc.)
• Areas affected by cigarette smoke (Do not smoke in
the room where this product is installed)
• Areas close to printers and affected by a toner
• Areas close to paper-handling devices, such as copy
machines, shredders, or fax machines, that are
affected by paper particles.
Reconsider the installation location if dust accumulates
at the tape slot and around the product within a few
months of installation.
When this product Generally, the data cartridge may write the tape
(the server if it is management data only when the tape (the data cartridge
built in the server) is for LTO) is ejected. Therefore, if the power of the tape
turned off or device is turned off while the tape is inside, a faulty tape
restarted, is the data where no management data can be written will be
cartridge ejected? created and problems such as data restore failure will
occur.
* Before turning off the data cartridge (the server), eject
the tape (the data cartridge for LTO).
Are two or more When using a single tape (data cartridge for LTO) over
data cartridges used and over for backup, important backup data can be lost
for backup and temporarily in the event the backup fails.
generation * Use two or more data cartridges for backup and
management? (Is a perform generation management.
different data
cartridge used every
time?)
Appendix A Operation Check Sheet(Installation/Operation Check)
Description / tasks (*)
E
87