Fujitsu PRIMERGY LTO3 User Manual page 81

LED Status
There is a problem with the cartridge that is
being loaded or that has just been ejected.
Ready
Drive Error
Tape Error
Clean
The following status It is possible that an error has occurred in
occurs when the the memory of the inserted cartridge.
cartridge is ejected
right after insertion.
Ready
Drive Error
Tape Error
Clean
The following status
occurs straight
cartridge is ejected.
Ready
Drive Error
Tape Error
Clean
A error has been detected.
Ready
Drive Error
Tape Error
Clean
There is a problem with the firmware
download.
Ready
Drive Error
Tape Error
Clean
A firmware error has occurred.
Ready*
Drive Error*
Tape Error*
Clean*
*LEDs turn on
alternately and
repeatedly.
Problem Solution
Insert the cartridge again. If this problem
occurs again there is something wrong with
the cartridge. Replace the damaged
cartridge with a new data cartridge.
In the case of a cleaning cartridge the
maximum number of times it can be used
has been exceeded. Replace the cleaning
cartridge with a new one.
If the cartridge is prohibited from
performing write operations data can be
read by inserting the cartridge. After the
data has been restored do not use this
cartridge again.
Insert a new cartridge and check if this
solves the problem. If this does not solve
the problem restart the server.
This problem will not occur during normal
operations. If this occurs at any other time
than when firmware is being rewritten
insert the cartridge and check if the
problem has been solved. If this does not
solve the problem restart the server.
Restart the server.
E
81
6 LEDs