Printing Hard-To-Dry Media - Roland Hi-Fi Express FP-740 User Manual

SHEET POS.
SAVE
W 1839 mm
SETUP SHEET
Description
Depending on the type of media, it may not be possible to detect the width of the media automatically. If this
happens, you must set the media type to "CLEAR" and make the setting for the width manually. To set the width, enter
the width of the media you're using, then save the location of the media's right edge. Failing to set the location of the
right edge or setting it at a location different from the actual right edge of the media may cause ink to be applied at
locations where no media is present.
SHEET POS.
CANCEL
Note that to keep the heads from drying out, the [SHEET POS.] menu ends automatically after a certain interval, even
if you're still making settings there.
The settings for the media width and start position made here are effective only when [SHEET TYPE] is set to [CLEAR].
Selecting [OPAQUE] disables the settings, although the setting values are saved in memory. Choosing [CLEAR] again
enables the values set previously.
Default Setting
[SHEET TYPE]: OPAQUE
[SHEET WIDTH]: 1879 mm

Printing Hard-to-dry Media

Procedure
MENU
SUB MENU
SUB MENU
SCAN INTERVAL
SCAN INTERVAL
OFF
1.0 sec
W 1839 mm
SETUP SHEET
After positioning, close the front cover.
Press
Press
Press
To quit making settings at the [SHEET POS.] menu, use
CEL], then close the front cover and press
Press
Press
Press
Press
Press
Use
Press
Press
Press
4-5 Accommodating Various Kinds of Media
to enable the setting.
.
to go back to the original screen.
.
.
several times.
.
several times.
.
to set the value.
.
.
to go back to the original screen.
Chapter 4 Feature Reference
to select [CAN-
81