Mounting The Switch On A Wall - H3C S5560S-SI Installation Manual

Mounting the switch on a wall

CAUTION:
•
Before drilling holes in a wall, make sure no electrical lines exist in the wall.
•
Leave a minimum clearance of 10 mm (0.39 in) around the chassis for heat dissipation.
The S5120V2-SI switch, S5120V2-LI switch, S5000V3-EI switch series, and S3100V3-SI switch
series support wall mounting. These switches are provided with screw anchors and screws as shown
in Figure 13
Figure 13 Screw anchor and screw
Table 5 describes the switch models that support wall mounting and installation holes distances
required for wall-mounting the switch.
Table 5 Installation hole distances for switch models that support wall mounting
Switch model
S5120V2-10P-SI
S5120V2-10P-LI
S3100V3-10TP-SI
S3100V3-18TP-SI
S5120V2-20P-LI
S5016PV3-EI
S5120V2-10P-PWR-LI
S5120V2-12TP-HPWR-LI
S3100V3-10TP-PWR-SI
S3100V3-20TP-PWR-SI
To mount the switch on a wall:
1. Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
See Table 5
for wall-mounting.
for the distance requirement between the two holes.
Hole distance
170 mm (6.69 in)
172 mm (6.77 in)
176 mm (6.93 in)
102 mm (4.02 in)
116 mm (4.57 in)
13