Sfp+ Port - H3C S5560S-SI Installation Manual

GE SFP
transceiver
module/cable
0-BIDI
modules in
pairs.
SFP-
GE-L
H70-S
M155
0-BIDI
SFP cable
SFP-STACK-Kit
Table 29 FE SFP transceiver modules
FE SFP transceiver
module
SFP-FE-SX-MM1310-A
SFP-FE-LX-SM1310-A
SFP-FE-LX-SM1310-D
SFP-FE-LH40-SM1310
SFP-FE-LH80-SM1550
SFP-FE-
LX-SM1
310-BIDI
SFP-FE-
LX-SM1
550-BIDI
NOTE:
•
As a best practice, use H3C transceiver modules and cables for the switch.
•
H3C transceiver modules and cables are subject to change over time. For the most up-to-date list of H3C
transceiver modules and cables, contact your H3C sales representative or technical support engineer.
•
For the specifications of H3C transceiver modules and cables, see H3C Transceiver Modules User Guide.

SFP+ port

The S5560S-28S-SI switch, S5560S-52S-SI switch, S5560S-28F-SI switch, S5500V3-SI switch
series, S5130S-SI switch series, and S5130S-LI switch series provide SFP+ ports. To connect SFP+
ports over a long distance, use SFP/SFP+ transceiver modules and optical fibers. To connect SFP+
ports over a short distance, use SFP+ cables. The SFP+ ports on the switch support the following
transceiver modules and cables:
Central
wavelength
•
TX: 155
nm
•
RX:
1490 nm
N/A
Central
wavelength
1310 nm
1310 nm
1310 nm
1310 nm
1550 nm
•
TX: 1310 nm
You must
•
use these
RX: 1550 nm
two
transceiver
•
TX: 1550 nm
modules in
•
RX: 1310 nm
pairs.
Cable
Connector
specifications
N/A SFP cable
Connector
LC
LC
LC
LC
LC
LC
LC
86
Modal
bandwidth
(MHz*km)
N/A
Max
Fiber transmission
distance
•
50/125 µm,
multimode
2 km (1.24 miles)
•
62.5/125 µm,
multimode
9/125 µm, single
15 km (9.32 miles)
mode
9/125 µm, single
15 km (9.32 miles)
mode
9/125 µm, single
40 km (24.86 miles)
mode
9/125 µm, single
80 km (49.71 miles)
mode
9/125 µm, single
15 km (9.32 miles)
mode
Max
transmission
distance
1.5 m (4.92 ft)