Table of Contents
Advertisement
2.
Place the switch with bottom up, and clean the round holes in the chassis bottom with dry cloth.
3.
Attach the rubber feet to the four round holes in the chassis bottom.
4.
Place the switch with upside up on the workbench.
Mounting the switch on a wall
CAUTION:
• Before drilling holes in a wall, make sure no electrical lines exist in the wall.
• Leave a minimum clearance of 10 cm (3.94 in) around the chassis for heat dissipation.
Table2-2
describes the switch models that support wall mounting and installation holes distances
required for wall-mounting the switch.
Table2-3 Installation hole distances for switch models that support wall mounting
Switch model
S1850V2-9P-EI
S1850V2-10P-EI
S1850V2-10P-PWR-EI
Use the provided screw anchors and screws to wall-mount the switch.
Figure2-8 Screw anchor and screw
To mount the switch on a wall:
1.
Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
See
Table2-2
Figure2-9 Installing the switch on a wall (1)
2.
Drill two holes with a diameter of 6 mm (0.24 in) and a depth of 25 mm (0.98 in) at the marked
locations. Hammer the screw anchors into the wall and use a Phillips screwdriver to fasten the
for the distance requirement between the two holes.
Hole distance
170 mm (6.69 in)
102 mm (4.02 in)
2-11
Advertisement
Table of Contents
