Mounting the switch on a wall
CAUTION:
• Before drilling holes in a wall, make sure no electrical lines exist in the wall.
• Leave a minimum clearance of 10 mm (0.39 in) around the chassis for heat dissipation.
Table2-2
describes the switch models that support wall mounting and installation holes distances
required for wall-mounting the switch.
Table2-3 Installation hole distances for switch models that support wall mounting
Switch model
S5130S-10P-EI
S5130S-12TP-EI
S5130S-20P-EI
S5130S-10P-HPWR-EI
S5130S-12TP-HPWR-EI
S5130S-16S-PWR-EI
S5130S-16S-UPWR-EI-Q
S5130S-10MS-UPWR-EI
S5130S-20P-PWR-EI
20 mm (0.79 in) long screws and screw anchors as shown in
switches for wall-mounting.
Figure2-10 Screw anchor and screw
20 mm (0.79 in)
To mount the switch on a wall:
1.
Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
Hole distance
170 mm (6.69 in)
176 mm (6.93 in)
102 mm (4.02 in)
116 mm (4.57 in)
Figure2-10
2-15
are provided with these