Operation With Servo Lag; Main Spindle - HEIDENHAIN TNC 370 D Technical Information

4.6 Operation with Servo Lag

Machine Function and input
parameter
MP1710.0-3 Position monitoring for control with servo
lag (erasable)
Input:
Recommended: 1.2 · servo lag
MP1720.0-3 Position monitoring for control with servo
lag (EMERGENCY STOP)
Input:
Recommended: 1.4 · servo lag
MP1810.0-3 k factor for control with servo lag
v
Input:
MP1820.0-3 Multiplication factor for the k v factor
Input:
MP1830.0-3 Characteristic kink
Input:

4.7 Main Spindle

Machine Function and input
parameter
MP3010 Output of rotational speed, gear range
Input:
0 = no output of spindle speed
1 = coded output of spindle speed, only if
the speed changes
2 = coded output of spindle speed on each
TOOL CALL
3 = analog output of spindle speed, but
gear change signal only if the speed
changes
4 = analog output of spindle speed, but
gear change signal on each TOOL
CALL
5 = analog output of spindle speed, but no
gear change signal
6 = same as input value 3 but with
controlled spindle for orientation
7 = same as input value 4 but with
controlled spindle for orientation
8 = same as input value 5 but with
controlled spindle for orientation
MP3020 Speed range for S code output
Input:
(with analog output of the spindle speed,
enter 1991 here)
4–60 TNC 370 D
0.000 to 1 000.000 [mm]
0.000 to 1 000.000 [mm]
0.100 to 10.000 [Fehler ] !
0.001 to 1.000
0.000 to 100.000 [%]
0 to 99 999
Machine Parameters
Change via Reaction
PLC
PLC
PLC
PLC
PLC
Change via Reaction
Reset
PLC
July 02