HEIDENHAIN TNC 370 D Technical Information page 90

Word Function
D592 Nominal position for oriented spindle stop
D596 Max. feed rate from PLC
D604 Max. spindle speed from the PLC
D756 Preset speed from the PLC; programmed speed
W764 % factor for spindle override
W766 % factor for feed-rate override
D768 Input values from MP4210.0 to MP4210.47
to
D956
W960 to Input values from MP4220.0 to MP4220.4
W968
W976 to Input values from MP4310.0 to MP4310.6
W988
W1008 S code for minimum speed
W1010 Rotational speed increment for S code
W1022 Error status of the last called module
W1024 Axis releases, bit-coded (5/4/Z/Y/X)
W1026 Axes in position, bit-coded (5/4/Z/Y/X)
W1028 Axes in motion, bit-coded (5/4/Z/Y/X)
W1030 Traverse direction, bit-coded (5/4/Z/Y/X) 0 = positive; 1 = negative
W1032 Reference marks not yet traversed, bit-coded (4/Z/Y/X)
W1034 Positive software limit switch was traversed, bit-coded (4/Z/Y/X)
W1036 Negative software limit switch was traversed, bit-coded (4/Z/Y/X)
W1038 Preparing to open the position control loop, bit-coded (4/Z/Y/X)
W1040 Opening the control loop, bit-coded (4/Z/Y/X)
W1042 No monitoring, bit-coded (4/Z/Y/X)
W1044 Actual position capture, bit-coded (4/Z/Y/X)
W1046 Manual traversing with + direction button, bit-coded (4/Z/Y/X)
W1048 Manual traversing with – direction button, bit-coded (4/Z/Y/X)
W1050 Incremental jog positioning +, bit-coded (4/Z/Y/X)
W1052 Incremental jog positioning –, bit-coded (4/Z/Y/X)
W1054 Reference end position, bit-coded (4/Z/Y/X)
W1056 Lubrication pulse. Value from MP4060.x exceeded, bit-coded (4/Z/Y/X)
W1058 Reset the accumulated distance for lubrication, bit-coded (4/Z/Y/X)
W1060 Axis-specific feed rate enable (4/Z/Y/X)
W1062 Axis-specific inhibiting of handwheel pulses
July 02
(PLC ® NC)
(PLC ® NC)
List of Markers and Words TNC 370 D 5–87