HEIDENHAIN TNC 370 D Technical Information page 61

Machine Function and input
parameter
MP1150 Delay time for erasing the nominal velocity
value after an erasable error message
Positioning error <Axis> #
Input:
Recommended: 0
MP1220 Automatic cyclic offset adjustment
Input:
MP1320 Direction for traversing the reference marks
Input:
Bit
Axis
MP1330.0-3 Velocity when traversing the reference
marks
Input:
MP1331.0-3 Velocity when leaving the reference end
position (only with MP1350=2)
Input:
MP1340.0-3 Axis sequence when traversing the
reference marks
Input:
0 = No evaluation of the reference mark
1 = Axis X
2 = Axis Y
3 = Axis Z
4 = Axis 4
MP1350.0-3 Functional sequence when traversing the
reference marks
Input:
0 = linear encoder with distance-coded
reference marks (old routine)
1 = linear encoder with one reference mark
2 = special run (linear measurement via
ROD)
3 = linear encoder with distance-coded
reference marks (new routine)
4–58 TNC 370 D
0.000 to 65.535 [s]
0 to 65 536 [s]
0 = no automatic adjustment
%xxxx
0 to 3 0 = not active
X to 4 1 = active
80 to 300 000 [mm/min]
80 to 500 [mm/min]
Machine Parameters
Change via Reaction
PLC
RUN
PLC
RUN
Reset
PLC
RUN
PLC
RUN
Reset
Reset
July 02