Touch Trigger Probes - HEIDENHAIN TNC 370 D Technical Information

3.7.13 Touch Trigger Probes

Any of the following touch trigger probes for workpiece measurement can be connected.
TS 220 Touch trigger probe with cable connection: for digitizing, workpiece setup and
workpiece measurement during machining
TS 630 Touch trigger probe with infrared transmission: for workpiece setup and workpiece
measurement during machining
X12 Touch Probe Input for Workpiece Measurement
Logic unit
D-sub terminal Assignment
(female) 15-pin
1 0 V
3 Ready
4 Start
5 +15 V ± 10% (maximum 100mA)
6 + 5 V ± 5% (maximum 100mA)
7
Battery warning
8 0 V (U
9 Trigger signal
10
Trigger signal
2, 11 to 15 Do not use
Housing External shield
Stylus at rest means logic level High
1)
3–28 TNC 370 D
)
N
1
Mounting and Electrical Installation July 02