Starting The Device For The First Time - Siemens SCALANCE X-300 Series Operating Instructions Manual

Description of the device

4.7 Starting the device for the first time

The C‑PLUG can be removed from the slot using flat pliers, tweezers, or a small screwdriver.
Product group Slot
X-300 Rear of the device
X-300M
XR-300M Rear of the device
- right
X‑300EEC Top of the housing
4.7 Starting the device for the first time
Note
When the device is started up for the first time, the power-up time is approximately 1 minute
longer than for all other starts of the device. The reason for this delay is the calculation of the
certificates required for encrypted communication. With SCALANCE devices, encrypted
access is possible via Web Based Management with HTTPS or via the Command Line
Interface with SSH.
96
Figure
1. Remove the screw cover.
2. Remove the C-PLUG.
3. Close the screw cover again correctly.
1. Remove the cover.
2. Remove the C-PLUG.
3. Close the cover again correctly.
1. Open the slider.
2. Remove the C-PLUG.
3. Close the slider.
Operating Instructions, 11/2019, A5E01113043-24
SCALANCE X-300