Pptp/Pppoe Encapsulation; Figure 5-5 Remote Node Network Layer Options - ZyXEL Communications Prestige 316 User Manual

FIELD
RIP Direction
Version
Multicast
Once you have completed filling in the Remote Node Network Layer Options menu, press [Enter] to
return to Menu 11. Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration,
or press [Esc] at any time to cancel.

5.2.2 PPTP/PPPoE Encapsulation

Make sure that Encapsulation is set to PPTP/PPPoE in Menu 11.1. Move the cursor to the Edit IP field
in Menu 11.1, then press [space bar] to toggle and set the value to Yes. Press [Enter] to open Menu 11.3
– Remote Node Network Layer Options.
Press Space Bar to Toggle.
Remote Node Setup
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
Press [space bar] to select the RIP direction from Both/None/
In Only/Out Only. Please see a previous section for more information
on RIP. The default for RIP on the WAN side is None. It is
recommended you do not change this setting.
Press [space bar] to select the RIP version from RIP-1/RIP-2B/
RIP-2M and N/A.
Turn on/off IGMP support and select the version from IGMP-v2/ IGMP-
v1/None.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Addr= N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= Yes
Metric= N/A
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
Press ENTER to Confirm or ESC to Cancel:
Figure 5-5 Remote Node Network Layer Options
Prestige 316 Broadband Sharing Gateway / Wireless LAN
DESCRIPTION EXAMPLE
None
RIP-2B
None
5-7