ZyXEL Communications Prestige 316 User Manual page 67

Prestige 316 Broadband Sharing Gateway / Wireless LAN
•
•
Enter the IP address of the WAN Ethernet port.
PPTP: My IP
Addr
PPTP: Server Enter the IP address of the ANT modem.
IP Addr
PPTP: Enter the connection ID or name in the ANT. It must follow the "c:id" and
Connection "n:name" format. This field is optional and depends on the requirements
ID/ Name of your xDSL modem.
Telco Option: This field sets a ceiling for outgoing call time for this remote node. The
default for this field is 0 meaning no budget control.
Allocated
Budget (min)
Telco Option: This field is the time period that the budget should be reset. For
Period (hr) example, if we are allowed to call this remote node for a maximum of 10
minutes every hour, then the Allocated Budget is (10 minutes) and the
Period (hr) is 1 (hour).
Telco Option: You can apply up to 4 schedule sets here. For more details, please refer
Schedules to the chapter on Call Schedule Setup.
Telco Option: This field specifies if you want to make the connection to this remote
Nailed-Up node a nailed-up connection. For more details, please see ahead.
Connection
Session This value specifies the idle time (i.e., the length of time there is no traffic
Options: Idle from the Prestige to the remote node) in seconds that can elapse before
Timeout (sec) the Prestige automatically disconnects the PPTP/PPPoE connection.
NOTE: This option only applies when the Prestige initiates the call.
Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic demand.
The Prestige does two things when you specify a nailed-up connection. The first is that idle timeout is
disabled. The second is that the Prestige will try to bring up the connection at power-on and whenever the
connection is down. A nailed-up connection can be very expensive for obvious reasons.
NOTE: Do not specify a nailed-up connection unless your telephone company
offers flat-rate service or you need a constant connection and the cost is of no
5-4
CHAP – use CHAP only.
PAP – use PAP only.
concern.
10.0.0.140
(default)
10.0.0.138
(default)
N:myISP
10
1
100
seconds
(default)
Remote Node Setup