Roland MODELA MDX-15 User Manual page 68

to the uppermost point.
Check to make sure that depth settings in the cutting data are not too deep, and that the tool extending from the spindle
unit is not too short.
Correct cutting is impossible
Are the cutting tool, spindle, and workpiece all installed and loaded securely?
Retighten the setting screw for the tool and the mounting screws for the spindle.
Unusual noise is heard from the spindle
The spindle unit is a consumable part. Replace with a new spindle unit after 700 hours of use.
The spindle motor does not run
The spindle motor is a consumable part. Replace with a new spindle motor after 700 hours of use.
The VIEW LED is flashing slowly (every 1 sec.)
Is the front cover detached?
Install the front cover.
When a sensor unit is installed, the VIEW LED does not flash.
The SCANNING LEDs repeatedly flashes twice
Something touched the sensor during initial operation immediately after switching on the power, or a
hardware error occurred.
If there is an obstruction, then switch off the power, remove the obstruction, and switch the power back on.
If there was a hardware error, then switch the power off and back on and repeat the same operation.
If the same error display occurs, consult your authorized Roland dealer or service center.
Unexpected Program Operation
I can't open a file.
Does the program you're using support the format of the file you're trying to open?
Check the program and the file format, and make sure the combination is supported.
There is not enough memory available for processing.
Close all other applications, or restart Computer.
If the file cannot be opened even after restarting the program, there may not be enough free space left on the hard disk.
If this is the case, free up space on the hard disk by deleting unneeded files or moving them to another disk.
If the messages about insufficient memory still appears after doing this, it is recommended that you increase the amount
of memory in your computer.
The included software doesn't function.
Does the computer you're using provide the correct operating environment for the included software?
Refer to the [Read Me] and check the operating environment, and use a computer that meets the operating-environment
requirements.
Was the software installed using the setup program?
Be sure to use the setup program when installing the software.
The setup program puts the files for each software package in the necessary locations to enable the software to be used
under Computer.
If an Error Message Appears
Refer to the help for the program you're using.
66 10 What to Do If...