Roland MODELA MDX-15 User Manual page 51

Method 2


Enter the Cutting Area
Enter the size of the plate installed on MODELA.



Set the Engraving Parameters
Make the settings for the composition of the workpiece to engrave and the engraving depth.
Choosing the composition sets engraving parameters suited to this engraving. However, [Tool Down Position] and [Fill] - [Tool
Width] are determined with no relation to composition, and so they are set separately. For [Tool Down Position], enter the
engraving depth. For [Fill] - [Tool Width], enter the tool diameter. The values for settings other than [Tool Down Position] and
[Fill] - [Tool Width] are also suggested guidelines. If the results of actual engraving are not as expected, modify the values
accordingly. Lines are distinguished by color, and parameters when engraving a line of the corresponding color are set.
From the [File] menu, click [Print Setup...].
The [Print Setup] dialog box appears.
Set the printer to [Roland MODELA MDX-20], and click
[Properties].
If you're using Windows 2000/XP, then click [Advanced].
Windows NT4.0:
Under [Document Options], click [Work Size Settings].
Windows 2000/XP:
Under [Document Options], click [Work Size Settings].
Click [Properties].
The [Print Setup] dialog box appears.
Click [Add New Work Size], then for [Work Size], enter
values for [Width] and [Length].
Enter the [Work Size Name], then click [OK].
9 Software Guide 49