Roland MODELA MDX-15 User Manual page 45


Make the settings for the scanning area.
Make the settings to match the location where the scan object is secured in place.
Either of the following two methods can be used to make the settings.
- Use the mouse to move the blue
frame on screen.
Blue frame




Check the scanning conditions in the Controller window one more time, then click
Scanning starts. (During scanning, the sensor may emit a transmission sound, but this is normal.)
- For the scanning area and Z upper limit, please refer to "7 Operation Guide [scanning section] About
scanning conditions and the scanning area".
- For detailed description of the available Controller buttons, please refer to the help screens for Dr.
PICZA.
- Enter the numerical values for the
upper-right and lower-left points.
The size of the on-screen scanning area (shown in blue) changes to
match the values that are entered.
Click [Begin Area Test].
The sensor moves to a position above an outer point on the scanning
area that has been set.
Make sure the scan object that has been secured in place lies within
the area.
Click [Z Upper Limit].
The cursor is displayed on the Z upper-limit setting on screen.
Specify the highest position of the scan object.
Clicking [Apply] or double-clicking on the target lowers the sen-
sors to the target's center position. If the target is displaced, redo
the settings.
* Set the Z upper limit to the highest position on the object to be
scanned. During scanning, if the sensor detects a position higher
than the Z upper-limit setting, the setting is cleared and scanning
continues with the greatest scan height of Dr. PICZA as the Z upper
limit.
After determining the scanning area, click [OK].
7 Operation Guide [Scanning Section]
.
43