Enter the Cutting Area
Enter the size of the plate installed on MODELA.
Set the Engraving Parameters
Make the settings for the composition of the workpiece to engrave and the engraving depth.
Choosing the composition sets engraving parameters suited to this engraving. However, [Z Down Position] and [Fill Pitch]
are determined with no relation to composition, and so they are set separately. For [Z Down Position], enter the engraving
depth. For [Fill Pitch], enter the tool diameter.
The values for settings other than [Z Down Position] and [Fill Pitch] are also suggested guidelines. If the results of actual
engraving are not as expected, modify the values accordingly.
Lines are distinguished by color, and parameters when engraving a line of the corresponding color are set.
Click the [Size] tab.
Enter values for [Width] and [Length].
Click the [Tool] tab.
Click the drop-down arrow for [Material], then click the
composition of the engraving material (workpiece).
Click the tab for the color to set.
The numeral appearing next to the color is the tool number that is
now set.
Click the drop-down arrow for [Tool], then click the tool
number.
If you don't wish to engrave lines of that color, click
[None].
9 Software Guide
47