Table of Contents
Advertisement
Press the TOOL-UP key to move the cutting tool away from the workpiece.
When you click the
Redo the setting at the
high location
4.
Perform Surfacing
In MODELA Player's [Layout/Surfacing Settings] dialog
P l a c e c u t
box, In the dialog box, drag the white circle to move it
deeper than
next to the black circle where you performed cutting in
the surface
"2. Verify the Cutting Position and Height When the Tool
Is Lowered." In this example, it's assumed that the black
circle shown in the figure was cut.
M o v e t h e
white circle
button, the cutting tool moves to the white circle.
Press the TOOL-DOWN key.
Release the key when the tip of the cutting tool touches
the surface of the workpiece.
The depth-direction reference point has now been reset.
Cutting tool
Workpiece
Lower the cutting tool at the four remaining corners with
the new reference point, and make sure that the workpiece
is not cut. (See "2. Verify the Cutting Position and Height
When the Tool Is Lowered" in the previous section.) If the
workpiece is cut, then repeat steps 2 and 3 and set a new
reference point.
* When you view the loaded workpiece edge-on from the side, if
there is any location higher than the four corners, then move the
cutting tool to that location and redo the setting for the depth-
direction reference point.
From MODELA Player's [Option] menu, click [Layout].
The [Layout/Surfacing Settings] dialog box appears.
6 Operation Guide [Cutting Section]
31
Hide quick links:
Advertisement
Table of Contents
