Table of Contents
Advertisement
32
6 Operation Guide [Cutting Section]
Enter the surfacing depth.
Here you set the cutting depth from the depth direction reference
point.
To change the range and location for surfacing, clear the
selection for [Automatic].
To change the range, drag the solid squares surrounding
the shaded area, or type in numerical values for [Width]
and [Length].
To change the location, drag the shaded portion or type in
numerical values for [Lowerleft X], [Lowerleft Y].
Click [Start] to start surfacing.
When surfacing ends, the depth-direction reference point is set at
the surface after surfacing.
When surfacing ends, click [OK].
Hide quick links:
Advertisement
Table of Contents
