Roland MODELA MDX-15 User Manual page 27


Set screw



About the Length of Tool Extending Beyond the Spindle Tip
Care is required regarding the length of tool extending beyond the spindle for the following reasons:
If too short, the tool tip will not reach the desired depth.
If too long, the tool may strike the workpiece when the tool is raised.
The restricted tool length varies according to the mounting location (height) of the spindle unit and the thickness
of the workpiece. For more information, go to "Attaching the Spindle Unit" and see the figure for "The Mounting
Locations for the Spindle Unit."
Use a hexagonal wrench (size : 1.5 mm) to attach the
included set screws to one side only.
* Insert the set screw straight and install.
Fit the spindle into place as shown in the figure.
Lift up the spindle until it touches, and while holding the
spindle in that position, use the included hexagonal (size :
3 mm) wrench to loosely tighten the screws you removed
in step 1.
After all four screws are in place, While supporting the
spindle by hand, tighten securely.
6 Operation Guide [Cutting Section] 25