Product Overview; Controls - Toro Reelmaster 3100-D Operator's Manual

Product Overview

Controls

Figure 31
1. Forward traction pedal
2. Reverse traction pedal
3. Mow/transport slide
Traction Pedals
Press the traction forward pedal
forward. Press the traction reverse pedal
31) to move backward or to assist in stopping when
moving forward. Also, allow the pedal to move or
move it to the
NEUTRAL
Mow/Transport Slide
Using your heel, move the mow/transport slide
31) to the left to transport and to the right to mow. The
cutting units operate only in the mow position.
Important:
The mow speed is set at the factory to
9.7 km/h (6 mph). It can be increased or decreased
by adjusting the speed stop screw
4. Tilt steering lever
5. Indicator slot
6. Angle indicator
(Figure 31) to move
(Figure
position to stop the machine.
(Figure
1. Jam nut
2. Speed stop screw
g008887
Tilt Steering Lever
Pull the tilt steering lever
the steering wheel to the desired position, then push
the lever forward to tighten.
Indicator Slot
The slot in the operator platform
when the cutting units are in the center position.
Angle Indicator
The angle indicator
angle of the machine in degrees.
Ignition Switch
(Figure
The ignition switch
shut off, and preheat the engine, has 3 positions:
O , O /P
FF N REHEAT
O /P
N REHEAT
32).
goes out (approximately 7 seconds); then rotate the
key to the S
Release the key when the engine starts. The key
automatically moves to the O
off the engine, rotate the key to the O
remove the key from the switch to prevent accidental
starting.
23
Figure 32
(Figure 31) back to adjust
(Figure
(Figure 31) indicates the side hill
(Figure 33), which is used to start,
, and S . Rotate the key to the
TART
position until the glow plug indicator light
position to engage the starter motor.
TART
/R
N UN
g336062
31) indicates
position. To shut
position and
FF