Attachment Power Lift; Adjusting Height-Of-Cut - Toro Wheel Horse Recycler 78355 Operator's Manual

Attachment Power Lift

The attachment power lift (Fig. 21) (some models) is
used to raise and lower attachments.
Raising Attachments
1. Start the engine, refer to; Starting and Stopping
the Engine; in tractor Operator's Manual.
2. Pull the lift lever in the "UP" direction to raise
the attachment lift (Fig. 21). This will lift and
hold the attachment in the up, or raised position.
Lowering Attachments
1. Start the engine, refer to; Starting and Stopping
the Engine; in tractor Operator's Manual.
2. Push the lift lever in the "DOWN" direction to
lower the attachment lift (Fig. 21). This will
lower the attachment lift.
2
1
Figure 21
1. Lift lever UP
m–2317
2. Lift lever DOWN

Adjusting Height-of-Cut

The rear gauge wheels are adjusted in different hole
location for 1-1/2–3-1/2" (4–9 cm) height-of-cut.
1. Pull height-of-cut lever out to disengage from
quadrant. Adjust height-of-cut to the desired
level. Release lever inward to lock into quadrant
(Fig. 22).
1
4
Figure 22
1. Height-of-cut lever
2. Quadrant
Operation
3
2
m–2827
3. Low
4. High
11