Installing Harness System - DJG Alpha Omega 65 Manual

C-9 Installing Harness System
1. Install Buckle Strap
From the front of child
restraint, push buckle strap's
metal retainer through pad and
shell. Make sure that buckle is
facing out.
2.
From bottom of child restraint,
pull buckle strap's metal
retainer completely through
pad and shell.
3.
Check Buckle
Pull up on buckle strap to
make sure it is secured.
The buckle must not pull out.
Failure to place buckle strap's metal retainer
completely through pad and shell can result in
serious injury or death to the child.
25
4358-5978 Alpha Omega ENG.indd 27-28 4358-5978 Alpha Omega ENG.indd 27-28
4.
Thread Harness Strap
NOTE:
the harness strap loop faces the
buckle before starting.
Thread the harness strap down
1 through lower harness guide
on left side of shell
2
bottom of shell and up through
lower harness guide on right
side (2).
NOTE: For easier assembly, remove the harness guides.
See section C-8, step 2.
5.
Make Harness Straps Even
Take both ends of the harness
strap and make them even in
length.
Do not twist harness straps.
Failure to place the harness
adjustment strap between
shell and the harness straps
as shown can result in
serious injury or death.
6.
Thread Harness Guides on
Harness Strap
Slide one harness guide on each
harness strap end.
7. Secure Harness Guides
Press harness guides into the holes
in the pad and shell.
26
Make sure sewn end of
(1) across
continued on next page.
11/9/12 3:44 PM 11/9/12 3:44 PM