Table of Contents
Advertisement
Installation Tip:
2.
Connect UAS to Vehicle UAS
Anchor Bar
Fasten one UAS hook to the UAS
anchor bar in the vehicle seat
bight. Repeat for other side of
child restraint.
3.
Tighten UAS Belt
Place knee in the child restraint.
Push down firmly while pulling up
on the free end of the UAS belt to
tighten.
It may be easier to tighten the belt
through the belt path opening as
shown.
4.
Tighten the Tether Strap
With knee still in child restraint,
push down on the child restraint
again and pull on free end of the
tether strap to tighten.
49
4358-5978 Alpha Omega ENG.indd 51-52
4358-5978 Alpha Omega ENG.indd 51-52
Loosely attach the
tether hook before
attaching the
UAS belt. Consult
vehicle's owner
manual for specific
location.
5.
Check UAS Belt Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the child
restraint from side to side,
forward and back. The child
restraint should not move
more than 2.5 cm (1 in)
and the UAS belt should not
loosen.
NOTE: If it moves more than 2.5 cm (1 in.) or if the UAS
belt loosens, try reinstalling the child restraint or try another
seating location.
Secure Child in the Child
6.
Restraint.
To Remove UAS Belt From
Vehicle Anchor Bar
Remove child from child
restraint. Press down firmly
on UAS adjuster on side of
child restraint and press the
UAS adjuster release button to
release the tension in the belt.
(1) Unhook the UAS hooks from
vehicle anchor bar by squeezing
1
the spring lever, push UAS hook
into the vehicle seat bight and
2
twist hook off the anchor bar.
(2) Pull UAS hooks away from
the UAS anchor bars.
50
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
