Table of Contents
Advertisement
G-3 Prepare UAS for
Forward-Facing Use
NOTE: Pull the UAS belt out of the rear-facing belt path if
you have used this child restraint rear-facing or remove from
the storage location.
1.
Routing UAS
Insert the UAS hook through the
forward-facing belt path.
The UAS adjuster can be on either
side, but the belt should not be
twisted.
2.
Pull UAS Hook Across to
Opposite Side
Pull the UAS hook across the back
and out the other side as shown.
Do not twist the UAS belt.
47
4358-5978 Alpha Omega ENG.indd 49-50
4358-5978 Alpha Omega ENG.indd 49-50
Adjuster
G-4 Install Forward-
Facing With UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only
if the belt can be tightened properly and
securely.
Do not fasten both UAS hooks on the same UAS
anchor bar in the vehicle.
Do not use any recline position except to
install the child restraint flush against the
vehicle seat back. Vehicle seat back must be
upright.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in
Vehicle Forward-Facing
Flush Against Back Seat
Do not use any recline
positions except to make the
child restraint flush against the
vehicle seat back.
NOTE: Do not use the level to
ground lines on the side of the
child restraint in the forward-
facing position.
48
continued on next page.
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
