Table of Contents
Advertisement
Quick Links
4358-3432E Enspira 5pt
8/6/07
Replacement Parts List
NOTE: If requested color is not available, similar color will be
substituted.
Part
Cost
Quantity Total Cost
Crotch Strap/Buckle $4.99 X______= $ ______________
Harness Strap . . . . .$2.00 X______= $ ______________
Full Wrap Pad . . . .$39.99 X______= $ ______________
Cup Holder . . . . . . .$2.99 X______= $ ______________
Harness Retainer . . .$1.50 X______= $ ______________
Locking Clip . . . . . . .$2.50 X______= $ ______________
Tether Kit . . . . . . . .$9.99 X______= $ ______________
Latch Kit . . . . . . . .$24.99 X______= $ ______________
Instructions . . . . . . .$0.00 X______= $ ______________
Merchandise Total:
Shipping and handling:
Up to $25.00 . . . . . . . . . .$5.95
$25.01 to $50.00 . . . . . . .$6.95
$50.01 to $75.00 . . . . . . .$8.95
$75.01 to $100.00 . . . . . .$9.95
Sales Tax
(Indiana, California, Arkansas, and Massachusetts residents add applicable
sales tax.)
Grand Total
No shipping and handling on instructions for quantities under 6. Add $.50 for
each instruction over 6, then add applicable shipping and handling.
Fill Out For Credit Card
Visa
Card Exp. Date: ______________________________
Cardholder's Name: __________________________
Card Number: ______________________________
Signature____________________________________
4:46 PM
Page 1
$ ____________
$ ______________
$100.01 to $150.00 . . . . .$10.95
$150.01 to $200.00 . . . . .$11.95
$200.01 and up . . . . . . . .$13.95
Outside Continental USA $10.00
$ ____________
$ ______________
Mastercard
58
E E n n s s p p i i r r a a
D D e e l l u u x x e e C C o o n n v v e e r r t t i i b b l l e e
C C a a r r S S e e a a t t
I I n n s s t t r r u u c c t t i i o o n n M M a a n n u u a a l l
www.djgusa.com
Read all instructions
BEFORE USING this child restraint.
KEEP INSTRUCTIONS FOR FUTURE USE.
IMPORTANT!
Failure to follow the warnings on the labels
and in the instruction manual can result in
the death or serious injury of your child.
Para recibir las instrucciones en español, llame al
1-800-544-1108 o solicitarse por escrito al dirección por arriba.
Eng. 4358-3432E
This child
restraint is
designed for
use by children
whose:
Weight:
5-80 pounds
(2.3-36.3 kg)
Height:
19-52 inches
(48-132.1 cm)
Advertisement
Table of Contents
Related Manuals for DJG Enspira
Summary of Contents for DJG Enspira
- Page 1 4358-3432E Enspira 5pt 8/6/07 4:46 PM Replacement Parts List NOTE: If requested color is not available, similar color will be substituted. Part Cost Quantity Total Cost Crotch Strap/Buckle $4.99 X______= $ ______________ Harness Strap ..$2.00 X______= $ ______________ Full Wrap Pad .
-
Page 2: Table Of Contents
4358-3432E Enspira 5pt 8/6/07 4:46 PM Before You Begin... Thank you for choosing this car seat, referred to throughout this manual as a child restraint.The DJG family is committed to creating a child restraint with the most comfort and convenience available today. -
Page 3: Warnings
4358-3432E Enspira 5pt 8/6/07 4:46 PM WARNING Failure to follow these warnings can result in the serious injury or death of your child. To help you recognize those instructions which are most critical for your child’s safety, we use this symbol... -
Page 4: General And Warm Weather Use
4358-3432E Enspira 5pt 8/6/07 4:46 PM WARNING Do not use this child restraint if the midpoint of your child’s head is above the top of the child restraint’s headrest. Never allow any child to play with this child restraint; it is not a toy. -
Page 5: Understanding Your Vehicle
4358-3432E Enspira 5pt 8/6/07 4:46 PM Understanding Your Vehicle Your vehicle’s features may be considerably different than those pictured here. Consult your vehicle owner’s manual to help identify your vehicle’s specific features. Page 9 A.Anchor Bracket For Top Anchorage Strap... -
Page 6: Child Restraint Parts
4358-3432E Enspira 5pt 8/6/07 4:46 PM Child Restraint Parts Shoulder Belt Body Pillow Guide (on select models) Adjustable Harness Strap Headrest Buckle Plate Harness Guides Buckle (on select models) Harness Release Harness Covers Lever (on select models) Harness Retainer Page 11... -
Page 7: Choosing Restraint And Position
4358-3432E Enspira 5pt 8/6/07 4:46 PM Choosing Restraint and Position Your child’s height, weight and age determine how your child restraint should be placed in the vehicle and which restraint should be used. 5-35 lbs (2.3-16 kg) 19-36 in. (48-91 cm) -
Page 8: Harness Height
4358-3432E Enspira 5pt 8/6/07 4:46 PM Press on harness retainer release button and pull apart. Press red button on buckle to release the buckle plates. Place harness over sides of child restraint. Lift headrest to the highest position by pulling headrest out while sliding up. - Page 9 4358-3432E Enspira 5pt 8/6/07 4:46 PM To change harness location: From the back of the seat, remove harness from splitter plate. Pull harness through the harness guides from the front. From back of child restraint, remove harness guides by pushing down on...
- Page 10 4358-3432E Enspira 5pt 8/6/07 4:46 PM To change harness location: From the back of the seat, remove harness from splitter plate. Pull harness through the harness slots from the front. Rethread harness into new harness slot location. Make sure harness does not twist.
-
Page 11: Securing Your Child In The Child Restraint
4358-3432E Enspira 5pt 8/6/07 4:46 PM Securing Your Child in the Child Restraint NOTE: Depending on your model, follow the unbuckling and buckling steps that matches your buckle plates. Position harness straps over the child’s shoulders. Push each buckle plate into buckle until you hear a “click”. -
Page 12: Reclining The Child Restraint
4358-3432E Enspira 5pt 8/6/07 4:46 PM Removing Your Child from the Child Restraint Loosen harness by pushing down on the harness release lever while pulling out on the harness. Remove child. Depending on your model, the harness release lever may be under a flap on the... -
Page 13: Choosing Latch Or Vehicle Belts
4358-3432E Enspira 5pt 8/6/07 4:46 PM Choosing LATCH or Vehicle Belts The LATCH System LATCH means Lower Anchor bars Anchors and Tethers for CHildren. Not all vehicles manufactured before September 2002 were equipped with LATCH. The LATCH system allows a child restraint to be... -
Page 14: Locking Clip
4358-3432E Enspira 5pt 8/6/07 4:46 PM Manual Belts Manual lap belts are common in the center rear seat and can allow the child restraint to loosen when it is tilted or jarred. After tightening the lap belt securely, tilt and push the child restraint forward and to both sides. -
Page 15: Rear-Facing Use
4358-3432E Enspira 5pt 8/6/07 4:46 PM Position locking clip about 1 in. (2.5 cm) from vehicle belt’s buckle plate. Rebuckle belt. Lap belt portion should now be tight. If not, remove locking clip and repeat all steps. Page 29 Rear-Facing Use... -
Page 16: Rear-Facing Installation
4358-3432E Enspira 5pt 8/6/07 4:46 PM Rear-Facing Installation After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they pertain to both systems. To use the child restraint rear-facing, make sure recline stand is folded under seat. -
Page 17: Latch
4358-3432E Enspira 5pt 8/6/07 4:46 PM Push down firmly on the child restraint and pull up on belt to tighten. For a manual belt, refer to “Knowing Your Vehicle Belts” section. Pull up on shoulder strap to remove any slack. - Page 18 4358-3432E Enspira 5pt 8/6/07 4:46 PM Push LATCH hook through the rear-facing belt path slot. Pull other end of LATCH hook in front of the buckle strap. NOTE: The crotch strap must be in the 1st and 2nd crotch strap slots (see “Preparing Child Restraint...
-
Page 19: Forward-Facing Use
4358-3432E Enspira 5pt 8/6/07 4:46 PM With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the LATCH belts do not loosen, your child restraint should be secure. NOTE: Some “play”... -
Page 20: Forward-Facing Installation
4358-3432E Enspira 5pt 8/6/07 4:46 PM Forward-Facing Installation After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they pertain to both systems. To install the child restraint, use either the recline mode or upright mode. -
Page 21: Latch
4358-3432E Enspira 5pt 8/6/07 4:46 PM With knee still in child restraint, attach hook to anchor in vehicle. Push down firmly and tighten top anchorage strap. To adjust top anchorage strap: See “Adjusting Top Anchorage Strap” section. NOTE: If your vehicle does not have an anchor bracket, tuck the top anchorage strap’s hook under the child... - Page 22 4358-3432E Enspira 5pt 8/6/07 4:46 PM Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle owner’s manual for locations and more information.
-
Page 23: Belt-Positioning Booster Use
4358-3432E Enspira 5pt 8/6/07 4:46 PM Adjusting the Top Anchorage Strap The top anchorage strap (tether) is used for the forward- facing position only. Most vehicles made after 9/1/99 already have the anchor hardware for a top anchorage strap. Refer to your owner’s manual or call your dealer. -
Page 24: Removal Of Harness
4358-3432E Enspira 5pt 8/6/07 4:46 PM Removal of Harness Harness must be removed for use as a belt-positioning booster. From the back of the seat, unfasten harness straps from splitter plate. Pull harness adjustment strap as far out as possible. -
Page 25: Belt-Positioning Booster Installation
4358-3432E Enspira 5pt 8/6/07 4:46 PM Belt-Positioning Booster Installation Child restraint must be in the upright position. Rotate recline stand out and push upward to lock in position. Place booster seat against the back of the vehicle seat.Tuck the top anchorage hook under the child restraint. -
Page 26: Reinstall Harness
4358-3432E Enspira 5pt 8/6/07 4:46 PM Reinstall Harness Reinstall Harness: Fit the buckle strap down through one of the three slots in the seat. Make sure buckle faces out. From the bottom of seat, pull buckle metal clip completely through pad and shell. -
Page 27: Removing Seat Pad For Cleaning
4358-3432E Enspira 5pt 8/6/07 4:46 PM Removing Seat Pad for Cleaning Remove harness as described in the “Belt-Positioning Booster” section. WARNING Do not use this child restraint without the seat pad. Failure to do this can result in serious injury. -
Page 28: Troubleshooting
4358-3432E Enspira 5pt 8/6/07 4:46 PM Work pad around headrest and remove from plastic shell. Hand wash with warm sudsy water, rinse clean and air dry. Do not use bleach or other harsh cleaners. Do not dry clean. Spot clean harness straps. Do not machine wash. -
Page 29: Warranty
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 57 Warranty Dorel Juvenile Group, Inc. (DJG) warrants this product to the original retail purchaser as follows: This product is warranted against defective materials or workmanship for seven years from the date of original purchase. -
Page 30: Replacement Parts Order Form
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 59 Replacement Parts Order Form Complete the form below. Your model number with color code and manufacturer date code MUST be included on the form to ensure proper replacement parts. Your model number with color code and the date code can be found on a sticker on the side of child restraint.