Table of Contents
Advertisement
G-5 Install Forward-
Facing With Vehicle Belts
NOTE: Review section D-4 to determine what kind of vehicle
belts you have. Review your vehicle's owner manual for vehicle
seat belt use.
Do not use the UAS along with
the vehicle lap or lap/shoulder
belt. Secure UAS belts when
using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Do not use any recline position except to
install the child restraint flush against the
vehicle seat back. Vehicle seat back must be
upright.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in
Vehicle Forward-Facing
Flush Against Back Seat
Do not use any recline positions
except to make the child restraint
flush against the vehicle seat
back.
NOTE: Do not use the level to ground lines on the side of the
child restraint in the forward-facing position.
51
4358-5978 Alpha Omega ENG.indd 53-54
4358-5978 Alpha Omega ENG.indd 53-54
Installation Tip:
Loosely attach
the tether hook
before threading
the vehicle belt.
Consult vehicle's
owner manual for
specific location.
2.
Thread Vehicle Belt
Thread the vehicle lap or lap/
shoulder belt through the
forward-facing belt path and
out the other side.
With an ALR vehicle belt, pull
the vehicle belt all the way out before threading the child
restraint.
With a switchable retractor, pull the shoulder belt all the
way out to switch the retractor into the ALR mode before
tightening.
Buckle vehicle belt.
3.
Tighten Vehicle Belt
Place knee in the child
restraint. Push down firmly
while pulling up on the
vehicle shoulder belt or lap
belt to tighten.
With a switchable retractor,
feed the shoulder belt back
into the retractor while
tightening.
It may be easier to tighten the
vehicle belt through the belt
path opening as shown.
52
continued on next page.
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
