Table of Contents
Advertisement
2.
Remove Lower Harness
Guides from Bottom of Seat
From the back, in the fully
upright position, locate the lower
Lower Harness Guides
harness guides that are between
the bottom of the seat and base
A
(A).
a.
Insert a flat head screw driver
into the hole in the base where
the lower harness guide is
located.
b.
Place the screw driver's tip
between shell and lower
harness guide, then twist the
screw driver while pulling the
harness guide from the front.
Repeat for other side.
3.
Remove Seat Pad
Adjust the headrest to the
lowest position. Pull pad off
the top of seat and around
headrest pad. Pull the pad
off the bottom of shell and
remove the pad.
23
4358-5978 Alpha Omega ENG.indd 25-26
4358-5978 Alpha Omega ENG.indd 25-26
4.
Remove Upper Harness
Guides
From the back of child restraint,
pinch harness guide ends
together or use a screwdriver to
Upper Harness Guides
press in on harness guide edge
as shown. With the other hand,
from the front of the restraint,
pull the harness guides out of
the headrest.
Remove headrest pad.
Cleaning Pad
Hand wash pad with warm sudsy water, rinse clean and air
dry. Do not use bleach or use other harsh cleaners. Do not dry
clean or machine wash.
Harness Straps: Spot clean only. Do not machine or hand
wash.
NOTE:
Do not wash the pad while still on the shell. Spot clean
only if it is not removed.
Do not use this child restraint or booster seat
without the seat pad. Failure to do this can
result in serious injury.
Install Pad
Replace seat pad by reversing order for your particular
model.
Slip headrest pad on and replace the upper harness
guides.
Starting from bottom of child restraint, slip pad on shell;
pull harness adjustment strap through pad.
Make sure pad is behind headrest and backrest.
Install lower harness guides.
Attach all of the elastic straps.
Install harness system (see section C-9).
24
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
