Table of Contents
Advertisement
F-4 Install Rear-Facing with
Vehicle Belts
Review section D-4 to determine what kind of vehicle belts
you have. Review your vehicle's owner manual for seat belt use.
Do not use the UAS along
with the vehicle lap or lap/
shoulder belt. Secure UAS
belts when using the vehicle
belts.
Check the vehicle belt before each use. Use
only if the belt is tightened properly and
securely.
Secure the tether hook to
the bottom of the base when
used rear-facing.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle that
matches the weight of your child. Do not use any
other recline positions rear facing. Do not rotate
the child restraint beyond the bottom or top level
to ground lines.
Failure to follow these warnings can result in
serious injury or death.
1.
Pull Pad Off Corners of Child
Restraint
Pull the seat pad off the front
corners of shell.
41
4358-5978 Alpha Omega ENG.indd 43-44
4358-5978 Alpha Omega ENG.indd 43-44
2.
Place Child Restraint in
Vehicle Rear-Facing in the
Back Seat
Fully recline the child
restraint. To recline, see
section C-6.
Rotate Child Restraint to
3.
Correct Recline Angle
For children between 2.3-
10 kg (5-22 lb), the bottom
level to ground line must be
level with the ground.
For children between
10-18 kg (22-40 lbs)
and are able to sit up
unassisted, rotate the child
restraint between the top and
bottom level to ground lines.
NOTE: Only if needed, you
may use a rolled towel(s) or
foam noodle(s) under the front
of the child restraint where
the vehicle's seat back meets
the vehicle's bench seat to get
the correct recline angle.
4.
Thread Vehicle Belt
Thread the vehicle lap or lap/
shoulder belt through the rear-
facing belt path.
With an ALR belt, pull the belt all
the way out before threading.
With a switchable retractor, pull the shoulder belt all the
way out to switch the retractor into the ALR mode before
tightening.
42
continued on next page.
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
