Harness Height - DJG Scenera Versa-Fit Overhead Barrier Instruction Manual

Table of Contents

Advertisement

4358-3775B Scenera OHB
5/30/06
4
5
6
Harness
Slot
Forward-Facing Position: Harness slots must be
even with or just above
the shoulders.
If the top harness slots are below the child's shoulders,
do not
use this child restraint. Use a belt-positioning
booster instead.
12
2:09 PM
Page 15
Press red button on
buckle to release the
buckle plate. Raise barrier
above child restraint.
Place the child's bottom
and back flat against the
child restraint.This will
increase comfort and
allow the harness to
properly tighten.
Check Harness Height
Rear-Facing Position:
Harness slot must be
even with or just below
the shoulders.
If the bottom harness
slots are above the child's
shoulders,
do not
use this
child restraint. Use an
infant child restraint
instead.
Determine which set of
7
harness slots works best
for your child. Adjust if
needed.
To change harness
8
location:
From the back of the seat,
remove harness from
splitter plate.
Pull harness through the
9
harness slots from the
front.
Rethread harness into new
harness guide location.
Refasten harness to
splitter plate. Make sure
harness does not twist.
WARNING
!
Failure to reattach the harness correctly,
can result in serious injury or death.
Determine which of the
10
three available crotch strap
slots is both comfortable
and snug. Refer to
"Removal of Harness" to
adjust buckle.
13

Advertisement

Table of Contents
loading

Table of Contents