Shoulder Belts - DJG Alpha Omega 65 Manual

H-2 Install Using the Lap and

Shoulder Belts

NOTE: DO NOT use the level to ground lines on the sides of the
shell. DO NOT use a locking clip when using this seat as a
booster seat.
1. Place Booster Seat in Vehicle
Forward-Facing Flush
Against Back Seat
Do not use any recline position
except to make the booster seat
flush against the vehicle seat back.
Vehicle seat back must be upright.
2.
Place Child in Seat
Place the child's bottom and back
flat against the booster seat. This
will allow the vehicle belt to be
properly tightened.
Adjust the headrest so that the
midpoint of the child's ears are at
the midpoint of the headrest.
3.
Buckle Lap and Shoulder Belt
Lap belt should cross the child's
thighs (not on the stomach). The
shoulder belt should lay snugly
across the center of the child's
shoulders and across the chest
(not on the face or neck). Pull up
on the shoulder belt to tighten.
55
4358-5978 Alpha Omega ENG.indd 57-58 4358-5978 Alpha Omega ENG.indd 57-58
4.
Position Shoulder Belt
To help position the shoulder
belt, you may need to secure the
shoulder belt in one of the two
shoulder belt-positioning guides.
NOTE: Use the shoulder belt
positioning guide only if necessary to correctly position the
shoulder belt on the child.
Check periodically to ensure your child has not moved out of
position and loosened the shoulder belt.
Do not use the
vehicle lap belt
only when using
this seat as a
booster seat.
The shoulder
belt must
always be
adjusted snugly
across the
child's chest.
NEVER place the shoulder belt behind
the child's back or under the child's
arms.
Failure to follow these warnings can
result in serious injury or death to your
child.
56
11/9/12 3:44 PM 11/9/12 3:44 PM