DJG Alpha Omega Instruction Manual

Hide thumbs Also See for Alpha Omega:

Advertisement

Quick Links

Replacement Parts List
NOTE: If requested color is not available, similar color will be
substituted.
Part
Cost
Quantity Total Cost
Crotch Strap/Buckle $4.99 X ____ = $ ____________
Harness Strap ............ $2.00 X ____ = $ ____________
Pad Set ...................... $42.00 X ____ = $ ____________
Chest Clip .................. $1.50 X ____ = $ ____________
Locking Clip ............... $2.50 X ____ = $ ____________
Tether Kit .................. $9.99 X ____ = $ ____________
Latch Kit ................... $24.99 X ____ = $ ____________
Instructions ................ $0.00 X ____ = $ ____________
Merchandise Total
Shipping and handling:
Up to $25.00 ......................$5.95
$25.01 to $50.00 ................$6.95
$50.01 to $75.00 ................$8.95
$75.01 to $100.00 .............$9.95
$100.01 to $150.00 ...........$10.95
Sales Tax
(Indiana, California, Arkansas, and Massachusetts residents add applicable
sales tax.)
Grand Total
No shipping and handling on instructions for quantities under 6. Add $.50 for
each instruction over 6, then add applicable shipping and handling.
Fill Out For Credit Card
q
Visa
q
Card Exp. Date: _____________________________
Cardholder's Name: _________________________
Card Number: _______________________________
Signature ___________________________________
58
4358-5843A US All in One.indd 1-2
4358-5843A US All in One.indd 1-2
$ _____________
$ ___________
$150.01 to $200.00 ...........$11.95
$200.01 and up ..................$13.95
Outside Continental USA $10.00
$ _____________
$ ____________
Mastercard
Alpha Omega
All in One
Instruction Manual
www.djgusa.com
Read all instructions BEFORE USING
this child restraint.
KEEP INSTRUCTIONS FOR FUTURE USE.
IMPORTANT!
Failure to follow the warnings on the labels
and in the instruction manual can result in
the death or serious injury of your child.
Eng. 4358-5843A
This child
restraint is
designed for
use by children
whose:
Weight:
5-80 pounds
(2.3-36.3 kg)
Height:
19-52 inches
(48-132.1 cm)
1/26/12 11:06 AM
1/26/12 11:06 AM

Advertisement

Table of Contents
loading

Summary of Contents for DJG Alpha Omega

  • Page 1 Replacement Parts List Eng. 4358-5843A NOTE: If requested color is not available, similar color will be substituted. Alpha Omega Part Cost Quantity Total Cost Crotch Strap/Buckle $4.99 X ____ = $ ____________ All in One Harness Strap .... $2.00 X ____ = $ ____________ Pad Set ......
  • Page 2: Table Of Contents

    Table of Contents Thank you for choosing this car seat, referred to Warnings ..................2-4 throughout this manual as a child restraint. The DJG General and Warm Weather Use ..........5 family is committed to creating a child restraint with the Registration and Recall ..............5 most comfort and convenience available today.
  • Page 3: Warnings

    WARNING WARNING Failure to follow these warnings can result The vehicle or LATCH belt must stay in the serious injury or death of your child. tight at the belt path.When you switch from one mode to the next, review the sections To help you recognize those instructions of this instruction manual that apply to that which are most critical for your child’s...
  • Page 4: General And Warm Weather Use

    1. Park in the shade or where sun does not directly hit the the use of any child restraint accessories child restraint. except those provided by DJG. 2. Cover the child restraint with a sheet or blanket when not in use.
  • Page 5: Understanding Your Vehicle

    Understanding Your Vehicle Your vehicle’s features may be considerably different than those pictured here. Consult your vehicle owner’s manual to help identify your vehicle’s specific features. Anchor Bracket Air Bag For Top Anchorage Strap (Consult your vehicle (Forward-facing only) owner’s manual for all air bag locations) LATCH Anchors Seat Bight...
  • Page 6: Child Restraint Parts

    Child Restraint Parts Front Back Harness/Headrest Buckle Cup Holder Top Anchorage Adjuster (Tether) Strap & Harness Release (on select models) Hook Pillow Lever Level To Ground (on select models) (under flap) Locking Clip Lines (behind harness) Shoulder Belt Recline Lever Positioning Guide Splitter Plate Harness...
  • Page 7: Preparing Child Restraint To Fit Your Child

    Preparing Child Restraint to Fit Choosing Restraint and Position Your Child Your child’s height, weight and age determine how your You MUST make these adjustments with your child child restraint should be placed in the vehicle and which before you install the child restraint in the vehicle. restraint should be used.
  • Page 8: Check Harness/Headrest Height

    Check Harness/Headrest Height Accessories (on select models) Rear-Facing Position: Harness guide must be Harness Infant Pillow (on select even with or just below Guide models): the shoulders. The pillow provides extra If the harness guide is comfort for your child. above the child’s shoulders To remove the pillow, with the headrest in the...
  • Page 9: Securing Your Child In The Child Restraint

    Pull on harness adjustment Securing Your Child in the Child strap to tighten harness snugly. Restraint NOTE: A snug strap Position harness straps should not allow any over the child’s shoulders. slack. It lies in a relatively straight line without sagging.
  • Page 10: Removing Your Child From The Child Restraint

    Removing Your Child from the Reclining the Child Restraint Child Restraint This child restraint has 3 Loosen harness by pushing recline positions: down on the harness Rear-facing - Fully release lever that is under Recline. For children 5-22 the flap while pulling out lbs (2.3-10 kg), recline on the harness.
  • Page 11: Choosing Latch Or Vehicle Belts

    Choosing LATCH or Vehicle Belts Knowing Your Vehicle Belts Not all vehicle belts will work with this child restraint. The LATCH System You must determine if your vehicles belts are compatible with this child restraint. If you will use the LATCH means Lower Anchor bars LATCH system, refer to the LATCH section.
  • Page 12: Locking Clip

    Manual Belts Locking Clip Manual lap belts are NOTE: The locking clip is located on the back of the seat. common in the center You do not need a locking clip when using this seat as a rear seat and can allow belt-positioning booster.
  • Page 13: Rear-Facing Use

    Grasp both vehicle belts Rear-Facing Use together just behind the buckle plate and unbuckle. NOTE: If the buckle plate ends up behind the child restraint, grasp the belts to the outside of the child restraint, as close to the buckle plate as possible. Thread both portions of the vehicle belt onto the locking clip, as close to the...
  • Page 14: Rear-Facing Installation

    Rear-Facing Installation Rear-Facing Installation with Vehicle Belt: After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they With child restraint pertain to both systems. in the most reclined When LATCH is not position, place child available, fasten belt hooks restraint rear-facing in...
  • Page 15: Vehicle Belt

    With weakest hand Thread the vehicle lap at belt path, tilt and or lap/shoulder belt push the child restraint combination through the forward and back, and rear-facing belt slot. from side to side. If the seat belts do not loosen, your child restraint should be secure.
  • Page 16: Latch

    Push LATCH hook Rear-Facing Installation with through the rear-facing belt path slot. LATCH: Install LATCH Belt Do not use the LATCH system along with the adult lap or lap/shoulder belt. To thread LATCH belts: Pull the seat pad off the Pull other end of LATCH front corners of shell.
  • Page 17 Fasten one LATCH belt Rear-Facing Installation with hook to the anchor in LATCH: Install in Vehicle the vehicle seat located in the vehicle seat bight. The top anchorage strap Repeat for other side of and hook is not used child restraint. See your for rear-facing.
  • Page 18: Forward-Facing Use

    After checking for hot Forward-Facing Use seat and buckles, place child in child restraint. See “Securing Your Child in the Child Restraint” section. Recheck the recline angle to make sure it is reclined according to your child’s Lap Belt Lap/Shoulder Belt weight.
  • Page 19: Forward-Facing Installation

    Forward-Facing Installation Forward-Facing Installation with Vehicle Belts: After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warning below as they Place child restraint flush pertain to both systems. against the back of the vehicle seat forward- facing in the back seat.
  • Page 20: Latch

    With weakest hand at Forward-Facing Installation with belt path, tilt and push the child restraint forward LATCH Belt: Install LATCH Belts and back, and from side NOTE: Do not use to side. If the seat belts LATCH system along do not loosen, your with the adult lap or lap/ child restraint should be shoulder belt.
  • Page 21 Place one knee in the child After checking for hot restraint and push down seat and buckles, place firmly while pulling up on your child in the child the loop to tighten belt. restraint as described in the “Securing Your Child in the Child Restraint”...
  • Page 22 To Attach Top Adjusting the Top Anchorage Anchorage Strap: Put knee in child restraint Strap and push down; attach The top anchorage strap (tether) is used for the forward- hook to anchor in facing position only. vehicle to estimate how Most vehicles made after 9/1/99 already have the anchor much adjustment you hardware for a top anchorage strap.
  • Page 23: Belt-Positioning Booster Use

    Belt-Positioning Booster Use Removal of Harness Refer to the “Choosing Harness must be removed for use as a Restraint and Position” belt-positioning booster. section to make sure your child is at the proper From the back of the weight and height to seat, unfasten harness use the belt-positioning straps from splitter plate.
  • Page 24: Belt-Positioning Booster Installation

    Fully recline the child Belt-Positioning Booster restaint. Reach under the seat between base and Installation shell. Locate the buckle’s metal retainer. The top anchorage strap and hook is not used for belt-positioning booster use. Attach the tether hook to the bottom of the base as shown.
  • Page 25 WARNING Place lap belt across child’s thighs. Lock buckle. For vehicles with an air bag, but without a back seat, refer to your vehicle owner’s manual. Do Not Use only the lap belt when using this seat as a belt-positioning booster without the internal harness.
  • Page 26: Reinstall Harness

    With the sewn end of the Reinstall Harness harness strap facing the buckle, thread the harness Fit the buckle strap down through the slot on down through the slot the left side of shell. in the seat. Make sure buckle faces out. From the bottom of seat, pull buckle’s metal clip completely through pad...
  • Page 27: Removing Seat Pad For Cleaning

    From the back, pull Removing Seat Pad for Cleaning harness through the back. Make sure the harness Remove harness as described in the “Belt-Positioning goes OVER the metal Booster” section. bar. WARNING Do not use this child restraint without the seat pad.
  • Page 28 From the back, use a Remove harness guides in screwdriver to press in bottom of seat. on lip of harness guide From the back of the seat, and pop guides through locate the lower harness the front. Pull cover off guides that are between headrest.
  • Page 29: Troubleshooting

    In harness and it will be ready for next use. no event will DJG or the dealer selling this product be liable to you for any damages, including incidental or consequential damages, arising out of the use or inability to use this product.
  • Page 30: Replacement Parts Order Form

    Replacement Parts Order Form Complete the form below. Your model number with color code and manufacturer date code MUST be included on the form to ensure proper replacement parts. Your model number with color code and the date code can be found on a sticker on the side of child restraint.

Table of Contents