Table of Contents
Advertisement
F-3 Install Rear-Facing with
UAS
NOTE: Review your vehicle's owner manual for UAS belt use.
Do not use the vehicle lap or lap/shoulder belt
when using the Universal Anchorage System
(UAS).
Check UAS belt before each use. Use only if the
belt can be tightened properly and securely.
Secure the tether hook
to the bottom of the base
when used rear-facing.
Do not fasten both UAS hooks on the same UAS
anchor bar in the vehicle.
Fully recline the child restraint and rotate the
child restraint to the correct recline angle that
matches the weight of your child. Do not use
any other recline positions rear facing. Do not
rotate the child restraint beyond the bottom or
top level to ground lines.
Failure to follow these warnings can result in
serious injury or death.
1.
Place Child Restraint in
Vehicle Rear-Facing in the
Back Seat
Fully recline the child restraint.
To recline, see section C-6.
37
4358-5978 Alpha Omega ENG.indd 39-40
4358-5978 Alpha Omega ENG.indd 39-40
Rotate Child Restraint to
2.
Correct Recline Angle
For children between 2.3-
10 kg (5-22 lb), the bottom
level to ground line must be
level with the ground.
For children between
10-18 kg (22-40 lbs)
and are able to sit up
unassisted, rotate the child
restraint between the top and
bottom level to ground lines.
NOTE: Only if needed, you
may use a rolled towel(s) or
foam noodle(s) under the front of the child restraint where
the vehicle's seat back meets the vehicle's bench seat to
get the correct recline angle.
3.
Connect UAS to Vehicle's
UAS Anchor Bar
Fasten one UAS hook to the
UAS anchor bar in the vehicle
seat bight. Repeat for other
side of child restraint.
4.
Tighten UAS Belt
Push down firmly on the
child restraint and pull up on
the free end of the UAS belt
to tighten.
It may be easier to tighten
the UAS belt through the belt
path opening as shown.
38
continued on next page.
11/9/12 3:44 PM
11/9/12 3:44 PM
Advertisement
Table of Contents
