Removing The Cutting Unit - Toro Greensmaster 1021 Operator's Manual

4. Slide the cutting-unit-drive coupler onto the
transmission driveshaft
The coupler should slide onto the transmission
driveshaft without resistance. If there is
resistance, ensure that the reel driveshaft and
the transmission driveshaft are aligned.
You can adjust the reel driveshaft position by
adjusting the reel-drive-assembly position:
A. Loosen the bolt shown in
Figure 35
1. Reel-drive assembly
B. Rotate the reel-drive assembly so that the
reel driveshaft is properly aligned with the
transmission driveshaft.
C. Tighten the bolt that you previously
loosened.
If resistance continues, adjust the engine and
transmission alignment; refer to the Service
Manual.
5. Install the grass basket.
(Figure 34).
Figure 35.
g304660
2. Bolt

Removing the Cutting Unit

1. Move the kickstand to the C
position; refer to
2. Remove the grass basket (if equipped).
3. Release the cutting-unit-drive coupler from the
transmission driveshaft
1. Cutting-unit-drive coupler
4. Remove the socket-head screws that secure the
cutting unit to the frame
5. Remove the cutting unit from the frame.
29
-U
UTTING NIT
Kickstand (page 10).
(Figure 36).
Figure 36
2. Socket-head screw
(Figure 36).
-S
ERVICE
g304661