Removing the Cutting Unit
Note:
The hex tube disengages if you engage the
reel drive when the cutting unit is removed.
1.
Move the kickstand to the C
position; refer to
2.
Remove the grass basket (if equipped).
3.
Move the collar
transmission-shaft groove.
Note:
This releases tension from the spring.
4.
Slide the hex tube off of the cutting-unit coupler
shaft
(Figure
28).
Figure 28
1. Collar
2. Hex tube
5.
Move the suspension latches up to release the
cutting unit from the machine
6.
Remove the cutting unit from the frame.
-U
-S
UTTING
NIT
Kickstand (page
10).
(Figure
28) into the
3. Coupler shaft
4. Latches
(Figure
28).
Backlapping the Cutting
Unit
To backlap the cutting unit, perform 1 of the following
ERVICE
options:
•
Install the Access Backlap Kit (Model 139-4342)
and use a backlapping machine. Contact your
authorized Toro distributor to acquire this kit.
•
Use the InfoCenter to enter Backlap Mode.
To enter Backlap Mode, select B
S
ERVICE
backlap the cutting unit.
Note:
Once the bail is released, Backlap Mode
is disengaged. You can use the bail-catch fork
(shipped in the loose-parts bag) to secure the bail
in the engaged position.
Remove the bail-catch fork after your backlapping
is completed.
1. Bail-catch fork
g307907
31
menu. Follow the InfoCenter prompts to
Figure 29
2. Bail
from the
ACKLAP
g283627