Removing The Transport Wheels; Using The Choke Lever - Toro Greensmaster 1021 Operator's Manual

2. Ensure that the traction and reel-drive controls
are in the N
EUTRAL
3. Start the engine; refer to
(page 17).
4. Set the throttle control to S
the machine up, gradually engage the traction
drive, and slowly increase the engine speed.
5. Adjust the throttle to operate the mower at the
desired ground speed and transport the machine
to the desired destination.
Transporting the Machine Using a
Trailer
Use a trailer to transport the machine a considerable
distance. Use caution while loading and unloading the
machine onto the trailer.
1. Carefully drive the machine onto the trailer.
2. Shut off the engine, engage the parking brake,
and turn the fuel valve to the O
3. Use a full-width ramp for loading the machine
into a trailer or truck.
4. Securely fasten the machine to the trailer.
Note:
You can use the Toro Trans Pro trailer to
transport the machine. For instructions on loading the
trailer, refer to your trailer Operator's Manual.
Important:
Do not run the engine while
transporting it on a trailer because damage can
occur to the machine.
Removing the Transport
Wheels
1. Release the clutch bail, use the throttle control to
lower the engine speed, and shut off the engine.
2. Move the kickstand to the
T -W
RANSPORT HEEL
Kickstand (page
3. Remove the transport wheels by pushing the
wheel-locking clips out of the axles
position.
Starting the Engine
, tip the front of
LOW
position.
FF
-S position; refer to
ERVICE
10).
(Figure
1. Axle
4. Carefully lower the machine off of the kickstand
by pushing forward slowly or by lifting the lower
handle support, allowing the kickstand to spring
back to the S
(page 10).

Using the Choke Lever

Use the choke lever to aid in starting a cold engine.
Move the lever to the C
cold engine. After the engine starts, move the lever
to the R position.
UN
15).
1. Choke lever—C
position
15
Figure 15
2. Wheel-locking clip
position; refer to
TORAGE
position when starting a
HOKE
Figure 16
2. Choke lever—R
HOKE
position
g274946
Kickstand
g273508
UN