Controls System Maintenance; Adjusting The Traction Cable - Toro Greensmaster 1021 Operator's Manual

Controls System
Maintenance
Adjusting the Traction
Cable
Adjust the traction cable to achieve a gap of 1.5 mm
(0.06 inch) between the friction disc and the pressure
plate.
1. Access the friction disc and pressure plate by
removing the clutch cover
Figure 28
1. Clutch cover
2. Loosen the jam nuts and adjust the traction
cable so that a 1.5 mm (0.06 inch) gap is
between the friction disc and the pressure plate
(Figure 29 and Figure
(Figure 28).
g274480
2. Bolt
30).
1. Traction cable
1. Friction disc
2. Pressure plate
26
Figure 29
2. Jam nut
Figure 30
3. Gap—1.5 mm (0.06 inch)
g274532
g274479