Programming An Already Programmed Bell Button; Basic Principle; Method 1: In-House Station Not Accessible; Programming The Other Already Programmed Bell Buttons - TCS PDS Series Product Information

PI_GB_PES_PDS_Art0015689_1v0.doc 14

Programming an already programmed bell button

Basic principle

A bell button can be linked to two serial numbers (of two in-house stations). It is then pos-
sible to have two different in-house stations ring at the same time.
Connect the in-house stations to the TCS:BUS.
Use one of these two methods.

Method 1: In-house station not accessible

LED illuminates
1
Press briefly
2
Floor-switch button within 3 sec:
press 1 sec, until bell rings - release - press 1 sec until bell rings - release.
3
Press
until
Prog2 tone sounds
4
Press briefly

Programming the other already programmed bell buttons

• Step 1
• repeat steps 2 and 3 each time
• complete the programming of all buttons with step 4
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com
LED flashes
... and
Noprog tone
1)
... sounds
LED illuminates
... and ring tone sounds release
at front-door and
in-house station.
programming
mode
of system
switched on
bell button
programmed
programming
mode
of system
switched off
Subject to change without notice.
Art.Nr. 0015689 Version 1.0 mi
10/2005