Programming A Bell Button; Method 1: In-House Station Not Accessible; Programming The Other Bell Buttons - TCS PDS Series Product Information

PI_GB_PES_PDS_Art0015689_1v0.doc 12
Connect the in-house station to the TCS:BUS.
Use one of these two methods.

Method 1: In-house station not accessible

LED illuminates
1
Press briefly
2
Floor-switch button within 3 sec:
press 1 sec, until bell rings - release - press 1 sec until bell rings - release.
3
Press briefly
4
Press briefly

Programming the other bell buttons:

• Step 1
• repeat steps 2 and 3 each time
• complete the programming of all buttons with step 4
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com

Programming a bell button

LED flashes
ring tone sounds at front-door and in-house station
LED illuminates
programming
mode
of system
switched on
bell button
programmed
1)
programming
mode
of system
switched off
Subject to change without notice.
Art.Nr. 0015689 Version 1.0 mi
10/2005