Cable Connection; General Notes; Connection; 2-Wire Special Mode - TCS PDS Series Product Information

PI_GB_PES_PDS_Art0015689_1v0.doc 8

General notes

Use the small screwdriver supplied to connect the lines and prevent damage to the
device.
!
Please note
• the lines should not be run in front of the LED to prevent obstruction of the name-
plate illumination
• the lines must not be squeezed below the spacers on the back of the front-station.

Connection

1. Strip the insulation from the line ends.
2. Connect the lines, depending on system type, in accordance with the connection dia-
gram.

2-wire special mode

In this mode only one front-door station can be con-
nected! A P-wire has to be made by bridging termi-
nals a and P.
Note: The front-station does not work if the bridge is connected
to b instead of a.

Wiring example

• To connect a door release relay use
the R terminal.
• A door release contact can be
connected to the S terminal. This
allows for checking whether the
triggered door is open or closed.
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com

Cable connection

Subject to change without notice.
Art.Nr. 0015689 Version 1.0 mi
10/2005