Commissioning; Microphone And Loudspeaker Volume Setup; Nameplate Labelling - TCS PDS Series Product Information

PI_GB_PES_PDS_Art0015689_1v0.doc 9
• Fully install the devices of the system.
• Check the a and b wires for short circuits.
• Connect the power supply and control units to the mains voltage.
Switch on the mains supply.

Microphone and loudspeaker volume setup

!
For adjustments use the small screwdriver supplied!
The volumes have been set to an average value
at factory. A modification may not always be
necessary.
When adjusting please note:
The amplification of loudspeaker and microphone
cannot be set independently from each other.
Too great volume will cause a feedback effect
(whistling).
The templates are available on our website
www.tcs-germany.com
System and technology basics\ Product installa-
tion and use \ labelling of the nameplate
1. Enter the desired name into the template.
2. Print the name plate on the special film* and
cut it to size.
3. Loosen the pockets at the outer edge of the
name plate glass using the insertion aid sup-
plied.
4. Insert the cut plates from the side into the po-
ckets on the name plate glass.
*
We recommend to print the name plates on a durable special
film. The film can be ordered directly from TCS: Writable poly-
ester film for name plates DIN A4.
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com

Commissioning

Nameplate labelling

\ English\ Downloads \
Volume control
microphone loudspeaker
In-house station Front-door station
volume volume
adjustment adjustment
Subject to change without notice.
Art.Nr. 0015689 Version 1.0 mi
10/2005