Programming A Bell Button; Method 1: In-House Station Not Accessible; Programming The Other Bell Buttons - TCS VPES Series Product Information

Connect the in-house station to the TCS:BUS.
Use one of these two methods.

Method 1: In-house station not accessible

1 LED illuminates
Press briefly
2
Floor-switch button within 3 sec:
press 1 sec, until bell rings - release - press 1 sec until bell rings - release.
3
Press briefly
4
Press briefly

Programming the other bell buttons:

• Step 1
• repeat steps 2 and 3 each time
• complete the programming of all buttons with step 4
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone.: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com

Programming a bell button

LED flashes
ring tone sounds at front-door and in-house station
LED illuminates
13
Subject to change without notice.
PI_GB_VPES_VPDS_Art0016079_2v0.doc mi
programming
mode
of system
switched on
bell button
programmed
1)
programming
mode
of system
switched off
05/2006