Table of Contents
Advertisement
Figure 1. Removing the BMC card
4. Place the BMC card on an ESD mat.
Replacing the BMC card in the 8335-GTC, 8335-GTG, 8335-GTH, 8335-GTW, or 8335-GTX
system
To replace a the baseboard management card (BMC), complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Ensure that the release latch of the BMC card is opened to about a 60-degree angle .
3. Align the BMC card with the rear of the system.
Use the plastic guides at (A) and the alignment pin (B) shown in Figure 2 on page 5 to help align the
card to the chassis.
4 Power Systems: Servicing the 8335-GTW
Advertisement
Table of Contents
