Table of Contents
Advertisement
Figure 166. Opening the ball valve
e) A second person is needed to raise the manifold assembly above the hose and the bucket so that
the water can drain from the manifold and the hose into the bucket.
f) Repeat step "6" on page 182 for the remaining water hose.
Replacing the water manifold in the 8335-GTW or 8335-GTX system
To replace a water manifold, complete the steps in this procedure.
Procedure
1. If the original manifold had the facility supply and return water hoses that exit at the top of the rack,
complete this step to reconfigure the replacement manifold. Otherwise, skip this step.
a) Unscrew and remove the four nuts of each manifold Z bracket by using a 7 mm nut driver. Remove
the three manifold Z brackets and separate the manifold halves.
Removing and replacing parts in the 8335-GTW or 8335-GTX 183
Advertisement
Table of Contents
