Table of Contents
Advertisement
Figure 120. Lifting out the system backplane
17. Place the system backplane on the ESD mat.
Replacing the system backplane in the 8335-GTW
To replace a system backplane, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the replacement system backplane from the static-protective package and place it on an
ESD mat.
3. Using the blue handles (A), lower the system backplane (B) into the system.
Removing and replacing parts in the 8335-GTW or 8335-GTX 135
Advertisement
Table of Contents
