Table of Contents
Advertisement
Figure 87. Remove GPU
Replacing the graphics processing unit in a water-cooled 8335-GTW or 8335-GTX system
To replace a graphics processing unit in a water-cooled system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the GPU from the protective packaging. Remove the protective covers from the bottom of the
GPU.
Remove the protective cover starting with its corner.
3. Using your labels, noting the orientation of the GPU, use the alignment pins under the GPU to carefully
insert the GPU onto the system backplane.
96 Power Systems: Servicing the 8335-GTW
Advertisement
Table of Contents
