Table of Contents
Advertisement
9. Using tweezers, carefully remove the TIM from the top of the system processor module and place it
in a clean, dry area as shown in Figure 111 on page 126.
The TIM can tear easily.
Figure 111. Removing the TIM from the system processor module
10. Remove dust and debris from the system processor module area.
If dust or debris is present, use the supplied air pump to clean the system processor module area.
Blow small bursts of air from the center toward the sides of the system processor module as shown
in Figure 112 on page 127. If your air pump is not assembled as shown in Figure 112 on page 127,
fasten the tip onto the bulb.
126 Power Systems: Servicing the 8335-GTW
Advertisement
Table of Contents
