Table of Contents
Advertisement
Figure 162. Disconnecting the water hoses
9. Remove the system from the rack.
CAUTION: This system requires two people to remove the system from the rack.
For instructions, see "Placing an 8335-GTC, 8335-GTG, 8335-GTH, 8335-GTW, or 8335-GTX system
into the service position" on page 209. If your rack has slider rails; remove the system from the rails.
10. Remove the rack rail on the side of the rack where the manifold is mounted.
11. Repeat step "7" on page 178 through step "10" on page 179 for each system in the rack.
Removing the water manifold from the 8335-GTW or 8335-GTX system
To remove a water manifold, complete the steps in this procedure.
Procedure
1. To close the valves, rotate the lever of the quick connect ball valve fittings of the manifold hose and
the facility water supply hose in the direction that is shown. Press the pin on the valve lever while you
rotate it 90 degrees to close it.
Removing and replacing parts in the 8335-GTW or 8335-GTX 179
Advertisement
Table of Contents
